? north america tel: 800.366.2266 ? europe tel: +353.21.244.6400 ? india tel: +91.80.4155721 ? china tel: +86.21.2407.1588 visit www.macomtech.com for addi tional data sheets and product information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 1 termination-insensiti ve biasable mixer, 1 - 6 ghz rev. v3 MDC-163 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. features ? lo drive: 0 dbm ? intermodulation ratio insensitive to if ports mismatches ? conversion loss: 7 db typical midband ? impedance: 50 ohms nominal ? maximum input power: 500 mw max. @ 25c, derated 6.4 mw/c ? low power: +24 dbm max. ? dc bias: +5, -5 vdc @12 ma each ? mil-std-883 screening available description the unique design of the termination insensitive mixer (tim) enables it to apply high reverse voltage to diodes during their ?off? phase, in the lo cycle. this allows for higher power level performance with minimum distortion. in addition the tim has internal loads that provide a good match and also absorb mixer generated lo frequency terms. combined, these features give the mixer its insensitivity to external mismatches, plus superior vswr. applied bias allows this mixer to perform at low lo power levels. c-2
? north america tel: 800.366.2266 ? europe tel: +353.21.244.6400 ? india tel: +91.80.4155721 ? china tel: +86.21.2407.1588 visit www.macomtech.com for addi tional data sheets and product information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 2 termination-insensiti ve biasable mixer, 1 - 6 ghz rev. v3 MDC-163 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. electrical specifications 1 : t a = -55c to +85c parameter test conditions frequency units min typ max frequency range rf, lo ports if port 1 - 6 10 - 2000 ghz mhz ? ? ? ? ? ? conversion loss 2 1 - 3 ghz 1 - 6 ghz db db ? ? ? ? 9.0 10.5 isolation lo to rf 1 - 2 ghz 2 - 6 ghz db db 10 13 ? ? ? ? lo to if 1 - 6 ghz db 13 ? ? rf to if 1 - 6 ghz db 15 ? ? rf input 1 db compression 1 db desensitization ? ? dbm dbm ? ? -2 -6 ? ? ssb noise figure within 1 db of conversion loss max. ? ? ? ? ? 3rd order input intercept 2.0 ghz 4.0 ghz 6.0 ghz dbm dbm dbm ? ? ? 7.0 8.0 5.0 ? ? ? 3rd order intercept degration @ if termination vswr 3:1 ? db ? 1.5 ? 1. all specifications apply when operated at +0 dbm av ailable lo power with 50 ohm source and load impedance. 2. for if frequencies of 10 - 500 mhz and an rf of ?10 dbm or lower. 3. independent of sum frequency match. this product contains elements protected by united states patent number 4,224,572
? north america tel: 800.366.2266 ? europe tel: +353.21.244.6400 ? india tel: +91.80.4155721 ? china tel: +86.21.2407.1588 visit www.macomtech.com for addi tional data sheets and product information. m/a-com technology solutions inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. 3 termination-insensiti ve biasable mixer, 1 - 6 ghz rev. v3 MDC-163 advanced: data sheets contain information regarding a product m/a-com technology solutions is considering for development. performance is based on target specifications, simulated results, and/or prototype measurements. commitment to develop is not guaranteed. preliminary: data sheets contain information regarding a product m/a-com technology solutions has under development. performance is based on engineering tests. specifications are typical. mechanical outline has been fixed. engineering samples and/or test data may be available. commitment to produce in volume is not guaranteed. typical performance curves ordering information part number package MDC-163 sma c-2
|
